How to Safely Remove Dead Palm Tree Fronds

Popular in warm southern areas, palm trees are fairly low maintenance, but when an overgrowth of dead fronds hangs down, you must remove them. If the tree’s not overly tall (some fingers may grow over 50 feet), this is a job to can take care of yourself.

Do not try to remove dead palm tree fronds throughout the summertime, or even before cooler weather. All these are helpful to the tree through the cold season as they insulate portions of the tree. Rather, remove the fronds or “skin” the tree through the spring when there is no more chance of frost. Skinning the tree involves removing the stalks which were left after pruning. It leaves the trunk smooth and manicured.

Tip: Some palms are self-cleaning and do not need pruning. Know what sort of palm you have before beginning.

Step 1 – Construct Your Applications
Removing the dead palm fronds isn’t a simple job. It requires using sharp knives and even a chainsaw to get the harder divisions. Jim’s Trees and Stump Removal provide best tree removal service in Perth. Make sure the chainsaw chain is sharpened, and you have the essential oil and gas mix. Also, sharpen any knives you are going to use.

The most important tool is the safety equipment. Gloves, powerful boots, and leg chaps will keep you from getting seriously injured and do not forget your protective eyewear.

No Harmonious source was Discovered for this video.
Hint: When pruning hands be quite careful to not damage the trunk. Use a ladder or lift truck to reach the dead fronds on tall trees, rather than scaling it using spikes.

Step 2 – Lay out Tarp
Put a tarp on the ground to make the cleanup of the old fronds simpler and to guard any flowers or other neighbouring plants.

Step 3 – Cut Fronds
Be very careful when reaching in and removing dead fronds, as some palm tree leaves are extremely sharp and contain tiny hairs which can irritate skin. Remove only fronds which are brownish and pointing. Removing a lot of green fronds will weaken the plant, and if done year after year may cause the fall of the tree. Leave all fronds that are growing upwards or horizontally.

To cut properly, grab the top section of the frond and hold it out right. Slice through the frond with your utility knife, or pruning saw. Cut these off as near as you can to the tree, but leave some of it. In case you have to use a spool on the heavier branches, keep both hands on the saw and try to obtain a straight angle to the trunk. You might need to remove a lot of dead fronds. This is fine as they’ll all grow back soon when the growing season starts.

Tip: Removal of those flowers and fruit is also advised. These both require a lot of energy to produce, so getting rid of them enables the tree to utilise that energy for development instead.

Step 4 – Skinning the Tree (Optional)
After you have cut the dead fronds off, you can spend some time skinning the tree. To do this, have a sharp knife to take out the base of the frond which has been left after pruning. Cut near the back, taking care not to damage it. The most frequent form of the cut palm tree is just a diamond shape. This is an optional step and can be prevented if you are pleased with the overall look of your palm after pruning.

Measure 5 – Wash Up
Place the dead fronds in a wheelbarrow and cart them to a fire or the local landfill. Contact your local city office for the codes or licenses necessary for cutting or disposing of dead palm tree fronds until you move.

Use a tree specialist if you are unsure of your skills.

Leave a Reply

Your email address will not be published. Required fields are marked *